Cone crusher because of its poor environment, dust, coupled with the use of some units to maintain the unit is not in place, often in the operation of a variety of problems, in general, the use of manipulation in the cone should pay attention to the following matters in order to ensure that Normal operation of the machine:
1, each running a certain period of time, it is best able to properly check the equipment and maintenance, this will make the equipment to maintain a better running state, get better production capacity and finished product quality.
2, conical broken to have the iron device to prevent the broken cavity over iron, if frequent over iron, it may cause broken shaft accident. If the uneven feeding will appear to reduce production capacity, product size is too large, frequent spring action, bowl bearing pressure, power consumption increased. Lubricant temperature can not be too high or too low, otherwise it will affect the machine running. (2) Check the torn and straight sets of wear and check the gap (3) Check the bevel gear meshing gap (4) Check the bowl gap (4) Check the clearance of the drive pad. But most of the familiar is that often referred to scale and short head type, the application of the two there is a certain difference: the distribution of feed size, in general, less than the mouth of the mouth of the material can not exceed 10% , If more than 10%, the power consumption increases, the product size becomes sheet.